Small Circular Lifting Magnet

Type LR25O-N

The Type LR 250-N is supplied  with built-in rectifier and switch and the unit is supplied  ready for connection to AC supply with approx.  3 meters long rubber  cable and safety plug.

The magnet body is a dynamo steel casting of high permeability. The exciter coil is wound of copper wire and cast into the casting with impregnating and sealing compound of good heat conductivity. Two pairs of suspension plugs, one on the top ,the other  at the side permit suspension of the magnet with pole face located  either horizontally  or vertically.

An integrally cast terminal box at the top encloses the cable terminals, rectifier set in single phase bridge connection  and switch.

Type LR25O-N 2

The Type LR 250-N2 has the same dimensions  and technical  specifications  ,but is supplied with separate control unit. The coils are however  designed for use with the control unit of Type SLV only.

SEPARATE  CONTROL  UNIT

TYPE : SLV-4 Dl25O

The control unit is designed  with a rectifier set in single phase  bridge connection, switch,  pilot lamp, fine wire fuse and interruptor (UT).

This control  unit is suitable  for one to four  magnets   and all magnets connected  to one control unit are switched  ON and OFF in common.