A SUPER FLUOROCARBON INTERBRAIDED PACKING without additives of any kind. This packing is virtually a premium packing because of its very low co-efficient of friction and it ensures immediate response to pressure changes. This packing is developed for pumps and valves handling highly corrosive liquids, where soft resilient packings are desired.

Services:
This packing is strongly recommended for Oxygen service, centrifugal shafts, mixers and agitators. A special packing for ammonia charge pumps, carbomate recycle pumps etc. involving high pressure application, acids and alkalies of any concentration. Not recommended to use on molten alkali metals.

Compressed Asbestos Fibre Jointing is a consistently uniform, solid run constructed and resilient product, a price worthy quality of dependable performance. Its adaptability to many sealing requirement makes this jointing the most Economical sheet packing choice of plant Engineers and maintenance men for low service conditions.
Red or Graphited finish.

A cost effective product manufactured from ecofriendly natural cellulosic fibres bonded with suitable mix of elastomers.
Colour: Red & Green

Services:
General purpose gasketing material suitable for use with Oils, Solvent, Gases, Water, L.P.Steam and most dilute acids and alkalies (low service conditions)

Large sizes made to order
Filled Materials*
Available if required

Cut Gasket as per size & drawing of Asbestos / Non-Asbestos Jointing & PTFE Gasket. Gasket must maintain a seal for an acceptable period against all of the operational forces involved and to achieve this, there are eight important properties which any good gasket should possess:

The Gasket should not be porous to the fluid being sealed.
The gasket should compress into the inperfections on the flange to create initial seal on application of sealing force.
Gasket should not show significant creep under the influence of load and temperature. Such flow will allow the bolts to relax, reduce gasket surface stress and cause leakage.
The gasket should be capable of catering to slight distortion between the flanges.
The gasket should withstand chemical attack from the media being handled.
The gasket has to be easily dismantled after use.
The gasket should be able to withstand effects of temperature of the confined media.
The gasket should not cause corrosion of the flange faces.

An advanced and adaptable valve stem/pump shaft packing material used for gland or stuffing box packing at site.

The self winding method and forming the required size of the gland packing at site is very practical and simple, especially as any dimension can be prepared quickly.

METHOD
A Pre-determined length of tape depending upon the radial width (the space between stem or shaft and the cylinder bore) is wrapped around the stem or shaft until the stuffing box is filled. The wound tape is then pushed down into the stuffing box and compressed to half its width by close fitting split pushers and the gland follower. With the help of a scale before and after compression of tape, the packing mechanic will be able to judge the extent of compression achieved. The stem or shaft under gland load should be turned every time before the next ring is formed. This process is repeated till the depth of the stuffing box is full.