The controller is a general‐purpose ultrasonic level controller that provides the end user the ability to control up to three unique devices (pumps, valves and/or alarms) through three relays, namely – Relay1 (DPDT, 2 form C), Relay2 (SPDT, 1 form C) and Relay3 (SPDT, 1 form C). The controller uses three push-buttons, SET, UP and DOWN for configuring the relay operation(s). All of the relays can be used for controlling valves, pumps or alarms.
[AG Echo] Ultrasonic level sensor which provides accurate range detection, automatic calibration and adaptive noise cancellation in software provide reliable and record measurement. All sensor used 4- stage op-amp based low noise amplifier, second order narrow band pass filter, peak-detector and low-pass filter circuit for detecting even the weakest of the reflected sonar signals. Various output options like pulses width, serial analogue 4 to 20 mA, 0 to 5 Volt etc. are available. Interface circuit options provide RS 232, 4 to 20 mA loop, 0 to 5 V DC, buzzer/relay and seven segment LED display. Accessories like mounting bracket rubber washer/nut faster etc. provide quick design and installation support.
Features:
SET, UP, DOWN push button configuration.
16x2 Line OLED or LCD display (as per user requirements).
Pump simplex, duplex and triplex option.
Integrated timer for pump / valve delay and pump alternation.
Ultrasonic Level sensors available in a 1m, 2m, 3m, 4m or 5m maximum range.
4/20 mA loop sensor output for indicating level.
110Vac or 230Vac or 24Vdc or 12Vdc powered (as per user requirements).
Specification :
Range : Ultrasonic level sensors available in 1M, 2M, 3M or 4M maximum range. (20 cm to 1m), (20 cm to 2m), (20 cm to 3m) or (20 cm to 4m)
Repeatability: 2 % or less
Loop Output: 4-20mA from Ultrasonic level sensor (200 ohms resistance on board of controller)
Dead band: 20 cm
Display indication: 16x2 Line OLED/LCD display
Configuration: SET, UP and DOWN Push buttons
Supply voltage: 180‐265 V ac or 90-130 Vac or 20 – 28 Vdc or 10 – 14 Vdc (as per user order)
Contact type: Relay 1, DPDT 2 form C relay Relay 2 and 3, SPDT, 1 form C relay
Contact rating: Relay1 - 28 Vdc/2A, 250Vac/1A Relay2 & 3 - 28 Vdc/4A, 250Vac/2A
Contact fail‐safety: Programmable / selectable
Temp. comp.: Automatic (through built in temperature sensor in ultrasonic sensor)
Ambient Temp.: 0 - 60°C (max)
Dimensions: 180mm x 120mm x 80mm (L x W x H).
Components:
The controller/sensor unit is offered as per following details.
Controller
Ultrasonic sensor (as specified by the user)
Sensor Gasket
Mounting Bracket
Quick Start Guide
