Canned Motor Pump is a combination of a centrifugal pump and an induction motor presented as an integral unit. In the canned motor Configuration the motor is mounted directly on the same shaft as the impeller.
Canned pumps are of simple design and construction, having very few parts and only two rotating parts-rotor and the impeller.
Secondary sealing is restricted to a couple of static gasket, which are again well confined.
Canned pumps do not required any external lubrication.
Canned pump is seal less and auxiliary support arrangements for cooling seals are not required.
Bush Bearings made out of carbon graphite and silicon carbide are the only parts that come up for replacement and the bearing have a very long life since there is no load on bearings, because of automatic thrust balancing, inherent in the design.
Canned pumps runs with negligible vibrations (<10 microns) and thereby wear and tear is greatly diminished.
Maintenance and operational cost are negligible compared  to conventional pump.
CANNED PUMPS NEVER LEAK – on continuous  or intermittent pumping or even in case of pump failure.
MONIBA PUMPS are certified FLAME PROOF/EXPLOSION PROOF (EEx-d IIB T6 (Ex) ds.).
Conform to AP1685, 1st edition for petroleum application.
Approved by leading consultancy in India.
Catering to wide range of service & duty conditions.
Available in all possible verity of construction.
Although the initial cost of canned pump is higher in comparison with conventional pumps, the advantages it offers – flawless pumping; minimum maintenance; negligible spares replacement; no hazards – contributes to definite cost-benefits, if the operating costs are computed even over 2-3 years time. Canned pumps will thereafter, prove tremendous economy in operation considering the minimum 15-20 year life cycle of the pump.

FEATURES AND BENEFITS:-

Features

No mechanical seal or its API systems
No coupling
No external lubrication
Vacuum light
Hermetically sealed with Secondary fluid Containment.
No rigid foundation.
Compact- saves 40%space.
Flame proof and explosion Proof.

Benefits

Zero emission
No alignment
No product loss
Longest MTBF
Low vibration and noise level
Negligible maintenance
Lowest cost of operation

An Ideal Selection for all Pumps Users.