Braco single compression Brass Cable Glands are suitable for armoured / unarmoured cables. These are manufactured out of brass castings and are machined accurately to the required sizes These glands are nickel plated to avoid corrosion while storage and use.

Braco Double Compression glands are manufactured out of brass rods/castings and are machined accurately to the required sizes. These are nickel plated to avoid corrosion whilst storage and use.

Braco Flange Type Cable Glands are made out of brass castings and are machined accurately to the required sizes. These glands are suitable for armoured calbes and are called mechanical glands hence suitable for outdoor application.

Braco BW Cable glands are as per BS 6121 Part 1:1989 and suitable for singel wire armoured plastic or rubber sheathed cables. These glands provide mechanical cable retention, and electrical continuity via armour wire ttermination. the use of these glands is recommended in dry, indoor situations. Shrouds may be used for ingress protection.

Braco CW Brass cable glands are as per BS 6121 Part 1:1989 and suitable for single wire armoured plastic or rubber sheathed cables. The outer seal grips sheath. These glands provide mechanical cable retention, and electrical continuity via armour wire termination. The use of these glands is recommended in indoor as well as outdoor application because of suitability in most climatic conditions weather proof and water proof.

Braco A2 type brass cable glands are as per BS 6121 Part 1:1989 and suitable for unarmoured, plastic or rubber sheathed cables. These glands provide outer seal joint and are suitable for indoor as well as outdoor applications.

Braco earth tags are made out of brass sheets and punched to the required sizes and are suitable for all sizes of cable glands. Electrical continuity is normally achieved via the screwed entry into metal boxes. For clearance hole entry situations it is essential to obtain direct metal-tometal contact between the gland, earth tag and the enclosure. These are used to ensure earth continuity between the gland and the equipment.

Braco black Polyvinyl chloride PVC shrouds are used for fitting over cable glands where additional protection against generous weather conditions and corrosion is required. They provide an effective seal onto both gland and cable oversheath as well as fast and simple installation. PVC shrouds also enhance the IP rating of a termination

Braco gland kits contain all that is necessary for terminating a cable run Gland(s), Earth tag(s), locknut(s) and shroud(s). Since the kits are ready to use hence are convenient and help to keep all parts for each termination together. The kits are easier to stock than loose pieces.